Table of Contents
Advertisement
11A-12-2
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
F9Q ENGINE –
REMOVAL SERVICE POINT
AA" OIL PLATE REMOVAL
(1) Remove the oil plate mounting bolts.
(2) Slide the oil plate toward the flywheel and then lift it off.
AB" CYLINDER BLOCK FRONT PLATE REMOVAL
(1) Remove the cylinder block front plate.
REN0192
INSTALLATION SERVICE POINTS
C
"AA CYLINDER BLOCK PLATE, FRONT
(1) Apply sealant to the cylinder block front plate.
REN0193
REN0192
"BA CRANKSHAFT FRONT OIL SEAL INSTALLATION
(1) Use the special tool to install the oil seal.
MB996040
REN0135
Jun. 2000
Mar. 2001
Oil Pan and Oil Pump
NOTE
Use care not to lose the pad attached on the cylinder
block front plate.
INSTALLATION
Specified sealant:
Rhodorseal 5661 or equivalent
NOTE
Do not apply too much sealant to avoid the risk of blocking
the oilways in zone (C). Remember to fit the chain pad
on the cylinder block front plate.
PWEE0001
PWEE0001-A
Revised
Advertisement
Table of Contents
