Advertisement
4.
Using supplied sheetmetal screws, screw two (2) screws per bracket into the dispenser wrapper, as shown
in Figure 14.
5.
Repeat Steps 1 through 4 for the opposite side of the dispenser.
6.
Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 5.
7.
Locate the icemaker mounting plates at the rear of the icemaker and position as shown in Figure 6, if plates
are not already installed.
NOTE: Kit contains two plates, both mounting plates must be installed.
8.
Using the plate as a template, drill 9/64 in. (0.140 in.) holes into the icemaker base and the dispenser, as
shown in Figure 7.
CAUTION: Be careful not to drill too deep and/or too fast into the icemaker base and dispenser
wrapper as damage may occur to unseen parts.
9.
Using the supplied sheetmetal screws, screw four (4) screws per plate into the dispenser wrapper and
icemaker base.
10.
Repeat Steps 7 through 9 on the other side of the dispenser.
I
NSTRUCTIONS FOR
WARNING: Failure to follow the installation instructions correctly may result in equipment damage
and/or personal injury.
The Parts shown in Table 5 are NOT Used for this Installation:
Part No.
22127
Icemaker Rear Mounting Plate
620053922
Left Side Adapter Hold-Down Bracket
620053923
Right Side Adapter Hold-Down Bracket
1.
Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 15.
© 2008, IMI Cornelius Inc.
Figure 14
30 I
W
I
NCH
IDE
CEMAKER
Table 5
Description
- 7 -
Icemaker & Adaptor Hold-Down Kit Installation Instructions
– IDC S
ERIES
U
NITS
Qty.
2
1
1
Publication Number: 629096853INS
Advertisement
