Advertisement
Icemaker & Adaptor Hold-Down Kit Installation Instructions
7.
Using the supplied sheetmetal screws, screw four (4) screws per plate into the dispenser wrapper and
icemaker base.
8.
Repeat Steps 2 through 7 on the other side of the dispenser.
I
NSTRUCTIONS FOR
WARNING: Failure to follow the installation instructions correctly may result in equipment damage
and/or personal injury.
The Parts shown in Table 4 are NOT Used for this Installation:
Part No.
620518916
Adaptor/Icemaker Side Hold-Down Plate (Flat)
1.
Locate the two right and left side hold down brackets, shown in Figure 2. These are the brackets with the
bent flange on them.
2.
Position bracket with the straight edge towards the rear of the unit, as shown in Figure 13. Also, the flange
of the bracket must be over the adapter lid, as shown in Figure 4.
Straight Edge of
Bracket Goes to
the Rear of the
Dispenser
3.
Using the bracket as a template, drill two 9/64 in. (0.140 in.) holes in the dispenser wrapper.
CAUTION: Be careful not to drill too deep and/or too fast into the dispenser wrapper as damage may
occur to unseen parts.
Publication Number: 629096853INS
Figure 12
N
-30 I
W
ON
NCH
IDE
Table 4
Description
Figure 13
I
– IDC S
CEMAKER
2
- 6 -
U
ERIES
NITS
Qty.
© 2008, IMI Cornelius Inc.
Advertisement
