Advertisement
Icemaker & Adaptor Hold-Down Kit Installation Instructions
CAUTION: Be careful not to drill too deep and/or too fast into the icemaker base and dispenser
wrapper as damage may occur to unseen parts.
9.
Install the second mounting plate on the other side of the icemaker base. Using supplied sheetmetal
screws, screw four (4) screws per plate into the icemaker base and dispenser wrapper.
I
NSTRUCTIONS FOR
CAUTION: Failure to follow the installation instructions correctly may result in equipment damage
and/or personal injury.
The Parts shown in Table 3 are NOT Used for this Installation:
Part No.
22127
Icemaker Rear Mounting Plate
620053922
Left Side Adapter Hold-Down Bracket
620053923
Right Side Adapter Hold-Down Bracket
1.
Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 8.
2.
Remove the two top black side panel screws from both sides of the Flavor Fusion unit (See Figure 1) and
save the screws.
Publication Number: 629096853INS
Figure 7
30 I
W
I
NCH
IDE
CEMAKERS
Table 3
Description
Figure 8
– F
LAVOR
2
1
1
- 4 -
F
U
USION
NITS
Qty.
© 2008, IMI Cornelius Inc.
Advertisement
