5.
Repeat Steps 1 through 4 for the opposite side of the dispenser.
6.
Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 5.
7.
Locate the icemaker mounting plates at the rear of the icemaker and position as shown in Figure 6, if plates
are not already installed.
NOTE: Kit contains two plates, both mounting plates must be installed.
8.
Using the plate as a template, drill 9/64 in. (0.140 in.) holes into the icemaker base and the dispenser, as
shown in Figure 7.
© 2008, IMI Cornelius Inc.
Icemaker & Adaptor Hold-Down Kit Installation Instructions
Figure 4
Figure 5
Figure 6
- 3 -
Flange on bracket
MUST Go Over the
Top of the Adapter
Lid as Shown.
Run a Continuous
Bead of Caulking
Around the Adapter
Top
Publication Number: 629096853INS