Table of Contents
Advertisement
Setting the screen to stay always on
The screen automatically turns off after a certain time. If you want to set the
screen to stay on all the time, follow the below instructions.
1.
Touch the
button on the control panel.
Select Settings, and then press the Dial Knob.
2.
3.
On the Settings screen, select Display, and then press the Dial Knob.
4.
On the Display screen, select Timeout, and then press the Dial Knob.
5.
Select Always on, and then press the Dial Knob.
NOTE
•
Energy consumption may increase depending on your setting.
•
When the timeout setting is set to "Always on", the brightness of the LCD
automatically changes to level 2 if there is no action for 3 minutes.
•
"Always on" setting is available only when the screen saver is set to On.
New oven smell
Before using the oven for the first time, clean inside the oven to remove the new
oven smell.
1.
Remove all accessories from inside the oven.
2.
Run the oven with Convection 200 °C or Conventional 200 °C for an hour. This
will burn any remaining production substances in the oven.
3.
When complete, turn off the oven.
NOTE
•
At the first-time use, you may see some smoke inside the oven while it is
operating. However, this is not a product failure.
•
As the temperature of the cooking room increases at an initial period, you
may find some spots on the inner glass of the door. If this is the case, turn
off the oven and wait until it cools down. Then, use kitchen paper or neutral
detergent with a clean cloth to wipe up the inner glass.
•
It is also important to make sure that you operate the oven in a well-
ventilating kitchen environment.
FULL_NV7B7970CAA_U4_DG68-01472D-00_EN.indd 13
FULL_NV7B7970CAA_U4_DG68-01472D-00_EN.indd 13
Smart safety mechanism
If you open the door while the oven is operating, the oven light turns on and
both the fan and the heating elements stop operation. This is to prevent physical
injuries such as burns as well as to prevent unnecessary energy loss. When this
happens, simply close the door and the oven continues to operate normally
because this is not a system failure.
Assembling the steam container (applicable models only)
1.
2.
3.
Check and make sure you have all the
parts for the steam container.
•
Parts includes glass lid, metal pan,
steam tray, and steam nozzle.
Insert the steam nozzle to the hole on
the right-rear side of the metal pan, and
then tighten the provided nut.
Put the steam tray in the metal pan,
and then close the glass lid to use it in
the oven.
English 13
2022-09-08 오후 6:03:03
2022-09-08 오후 6:03:03
Advertisement
Table of Contents
