Table of Contents
Advertisement
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
NOTE:
Ensure that the touchpad is aligned with the guides available on the palm-rest and keyboard assembly, and the gap on
either sides of the touchpad is equal.
1
Slide and place the touchpad into the slot on the palm rest and keyboard assembly.
2
Replace the four screws (M2x2) that secure the touchpad to the palm rest and keyboard assembly.
3
Adhere the tape that secures the touchpad to the palm rest and keyboard assembly.
4
Slide the touchpad cable into the connector on the system board and close the latch.
Post-requisites
1
Replace the battery.
2
Replace the
base
cover.
computer. After working inside your computer, follow the instructions in
Replacing the touchpad
www.dell.com/
22
After working inside
Replacing the touchpad
41
Advertisement
Table of Contents
