Table of Contents
Advertisement
24
www.aeg.com
Problem
You cannot activate the ap-
pliance.
You cannot activate the ap-
pliance.
The burners do not work.
There is no spark when you
try to activate the spark gen-
erator.
The flame extinguishes im-
mediately after ignition.
The flame ring is uneven.
The flame colour is orange
or yellow.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance makes noises.
The display shows "12.00".
Possible cause
The fuse is released.
The appliance is too hot.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
up sufficiently.
Burner crown is blocked with
food residues.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
There was a power cut.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Wait for the appliance to
cool down.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.
Make sure that the injector is
not blocked and the burner
crown is clean.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Some metal parts of the ap-
pliance expand and contract
when they heat up or cool
down. The noises are nor-
mal.
Reset the clock.
Advertisement
Table of Contents
