Lenovo 7Z59 Manual page 53

1. Check Lenovo support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If problem persists, collect Service Data log.
3. Contact Lenovo Support.
• FQXSPIO0014J: Bus [SensorElementName] is operating in a degraded state.
This message is for the use case when an implementation has detected a Bus is Degraded.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0246
User Action:
Complete the following steps to solve:
1. 1. Reseat the adapter or other slot.
2. 2. If the problem still exist then replace the adapter.
3. 3. If the problem still exist then contact local service.
• FQXSPIO0015M: Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName].
This message is for the use case when an implementation has detected a Fault in a slot.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0330
User Action:
Complete the following steps to fix the error:
1. Make sure that all I/O expansion adapters have correct and matching levels of device drivers and
firmware.
2. Check the event log of XClarity Controller for additional information about failing components. Check
http://support.lenovo.com/ for TECH tips or firmware updates that might correct the error.
3. If there are no entries related to the error in the event log, contact Lenovo support
• FQXSPIO2000J: The connector [PhysicalConnectorElementName] has been disconnected.
This message is for the use case when an implementation has detected a Connector was Disconnected.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0265
User Action:
Ensure the cables are connected correctly
.
Chapter 2 XClarity Controller events
49