Partlist Top Panel Left Door Bottom Panel Right Door Left Side Panel Left Drawer Side Right Side Panel Right Drawer Side Back Panel Drawer Back Drawer Base Divider Divider Drawer Front Shelf Panel Iron Pipe support Leg mocka.co.nz I mocka.com.au...
Page 3
The fixing device provided should fit most wall types, but please note that different wall materials may require different fixing devices from those supplied. Phillips & Flathead screwdrivers and hammer required For quicker assembly, we recommend the use of a power drill on a low-speed setting. mocka.co.nz I mocka.com.au...
Page 5
Edmond Buffet Hardware Needed mocka.co.nz I mocka.com.au...
Page 6
Edmond Buffet Hardware Needed Countersink front hole Hardware Needed back flat hole TURN OVER mocka.co.nz I mocka.com.au...
Page 7
Edmond Buffet Hardware Needed Hardware Needed Door x2 mocka.co.nz I mocka.com.au...
Page 8
Edmond Buffet Hardware Needed NOTE: If the doors are uneven or there is a gap in the middle, loosen or tighten the screw on the door hinge until they are sitting flush. Hardware Needed Drawer x3 mocka.co.nz I mocka.com.au...
Page 11
Edmond Buffet Carefully insert the drawers into the unit by gently guiding the runners into the tracks. Hardware Needed mocka.co.nz I mocka.com.au...
Page 12
Twist the adjuster on centre leg to make sure the top panel is flush. Once assembled lift furniture into place, do not drag.You’re done, enjoy! mocka.co.nz I mocka.com.au...
Page 13
MOVE DOOR OUTWARD by turning this screw clockwise by turning this screw counter-clockwise STEP 4 Adjust the Gap beteen door panel and side panel MOVE DOOR BACK OR Loosen this screw a bit. Re-tighten this screw. FORTH mocka.co.nz I mocka.com.au...
Need help?
Do you have a question about the Edmond and is the answer not in the manual?
Questions and answers