Advertisement
Installation
5. Bundle and cable-tie the two gray wires on the right
side of the main board as shown.
6. On HP Auto units only, do not cable-tie the white
solenoid wires.
7. Bundle and cable-tie the wires on the left side of the
main board as shown.
8
8. Install bottom cover with 4 screws (do not pinch
wires).
9. Connect battery after service.
10. Open prime valve to relieve pressure. Start engine
or turn ON striper and calibrate distance sensor per
the operation manual.
11. After calibration, use the arrows to select the set-
tings screen.
3A4240
Advertisement
