Connections & Indicators; Installation - Intellinet 560764 V1 Series Instructions Manual

Connections & Indicators
LEDs
The LED indicators make it easier to monitor
the switch and its connections. NOTE: Ports
1 – 8 can provide power to a connected
powered device, and all powered devices
should comply with IEEE 802.3at/af.
Ports
All RJ45 ports on the switch support
Auto-MDI/MDI-X functionality, so you can
use straight or crossover UTP/STP cables
to connect the RJ45 ports to PCs, routers,
hubs, other switches, etc. Cat5e/6 UTP/
STP cables provide optimal performance;
if a status LED doesn't indicate a link or
activity, check the corresponding device for proper setup and operation.
Power
Use the included power cord to connect the device (on the rear panel)
to an AC outlet. Confirm that the Power LED on the front panel is lit.

Installation

Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch;
• with at least 25 mm (approx. 1") of clearance for ventilation;
• away from sources of electrical noise: radios,
transmitters, broadband amplifiers, etc.;
• within 100 m (approx. 328') of network devices it's to be connected to.
For specifications, visit intellinet-network.com. Register your product at register.
intellinet-network.com/r/560764 or scan the QR code on the cover.
2 English
10/100 Mbps
LED Status Status Description
Off Power Off
Power
On Power On
Off No link established.
On Valid port connection.
LNK
Flashing Sending or receiving data.
No PD is connected
Off
to the port.
PoE
The connected device
On
is receiving power.
Power output is at or
MAX 1
above the maximum
(1-4);
On power budget. No
MAX 2
additional connected
(5-8)
devices will be powered.
Instructions