Connections & Indicators - Intellinet 560641 Instructions Manual

CONNECTIONS & INDICATORS
10 12 14 16
LEDs
The LED indicators make it
easier to monitor the switch
and its connections.
Ports
All ports on the switch support
Auto-MDI/MDI-X functionality,
so crossover cables and uplink
ports are not needed for
connections to PCs, routers,
other switches, etc. Cat5/5e/6
UTP/STP cables provide
optimal performance; if a status
LED doesn't indicate a link,
check the corresponding
device for proper setup and
operation.
Power
Use the included power cord to connect the device to an AC outlet. Confirm that the
power LED on the front panel is lit.
PLACEMENT
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch
• with a minimum of 25 mm (approx. 1") of clearance on the top and sides for adequate
ventilation
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.
• where it cannot be affected by excessive moisture
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it in place
with screws.
3 Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
2
560641_04_man_ML1.indd 2
LED
Power
PoE
LNK
MAX 1 (1-4) On
MAX 2 (5-8) On
ENGLISH
Status Operation
On Power on
Off Check the AC connection; turn the power on
On Port is linked to a PSE/PoE device
Off No PSE/PoE device is linked
On Valid port connection
Blinking Valid port connection; data transmitted/received
Off No link established
Power output (4 ports) > 55 W: Additional
connections may not receive power
Blinking Power output (4 ports) > 70 W (maximum)
Off Power output (4 ports) < 55 W or no link
established
Power output (4 ports) > 55 W: Additional
connections may not receive power
Blinking Power output (4 ports) > 70 W (maximum)
Off Power output (4 ports) < 55 W or no link
established
1/23/15 2:13 PM