Connections & Indicators; Rack Mount - Intellinet 560900 Quick Install Manual

PoE+ Web-Managed Gigabit Ethernet Switch
This guide presents the basic steps to set up and operate this device. For detailed
instructions and specifications, refer to the user manual on the CD enclosed with this
product or at intellinet-network.com.
CONNECTIONS & INDICATORS
2 4 6 8
B
F4
PoE
F3
LINK/ACT
F2
PoE
Power
Reset
F1 LINK/ACT
1 3 5 7
LEDs
The LED indicators (A) —
Power, PoE (1-24), Link/
Activity (1-24), SFP (F1-4) —
make it easier to monitor the
switch and its connections.
Ports
All ports on the switch
support Auto-MDI/MDI-X functionality, so crossover cables and uplink ports are not
needed for connections to PCs, routers, other switches, etc. Cat5/5e/6 UTP/STP cables
provide optimal performance; if a status LED doesn't indicate a link or activity, check
the corresponding device for proper setup and operation. The recessed Reset button
(B) can be pressed (using a pin or similar pointed object) to reset the switch if it isn't
responding. NOTE: SFP ports F1-4 (C) share connections with RJ45 ports 1-4
ports 1 and F1 are both connected to devices, only F1 will link.
Power
Use the included power cord to connect the device (next to
the On/Off switch on the rear panel) to an AC outlet.
RACKMOUNT
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it
in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
2
ENGLISH
10 12 14 16 18 20 22 24
A
9 11 13 15 17 19 21 23
LED
Power
PoE
Link/Act
& SFP
Combo
C
Status Operation
On Power on
Off Check the AC connection; turn the power on
On Port is linked to a PSE/PoE device
Off No PSE/PoE device is linked
On Valid port connection
Blinking Valid port connection; data transmitted/received
Off No link established
English
D
(D). If
ON
OFF