BEARING PRESS ASSEMBLY
LINK BEARING PRESS
3
1
Press both upper bearings into the link from the inside of the link tabs using a 15x24mm arbor.
Check that both bearings are fully seated.
2
Press the drive-side lower bearing into the link using a 15x24mm arbor, fully seating the bearing
into the link.
3
Install the lower bearing spacer against the pressed lower bearing. Press the non-drive side
bearing into the link until bearing bottoms against the spacer
EXTENDER BEARING PRESS
1
2
1
Press the bearing into the upper extender with the extended race facing out of the bore.
Press into the extender until fully seated.
2
Press the bearing into the lower extender with the extended race facing out of the bore.
Press into the extender until fully seated.
2
1
SB140
|
OWNER'S MANUAL
12