Yeti SB140/LR Owner's Manual page 10

07
Place 2x Race Extenders (3.5) onto the lower
bearings in Link Assembly (3.16). Install into front
triangle using Link Pivot Collet Axle (3.4) and
plain Collet Nut (3.2).
Torque: 25 Nm
10
Place 2x Race Extenders (3.5) onto the upper bearings in Link Assembly (3.16). Rotate Rear Triangle and
Link together, lining up SS Pivot bores.
Install 2x SS Pivot Screws (3.3) from the inside of the Link and partially into the Rear Triangle.
Place 2x plain Collet Nut (3.2) into the Rear Triangle.
Using a wrench from the outside of the Swingarm, begin tightening in the "left-hand" direction (this is
still a standard thread, but installed from the inside), tightening the SS Pivot Screw and Collet Nut.
Torque: 25 Nm
08
Assemble Upper (3.23) and Lower (3.22) Shock Extender to SB149 Link (3.16) by placing 2X Race
Extender (3.15) in the extender cavities and sliding between the Link tabs. Threaded Extender (3.23)
should be oriented to the top. Secure with a Guide Pin and assemble Female 8x41mm Bolt (3.17) with
Washer (3.21) through the assembly. Secure with Male M6 Bolt (3.19) and Washer (3.20).
Torque: 10 Nm
11
Install Large Collet Wedge Bolts (3.9) into
2x Collet Axles (3.1) and (3.4)
Torque: 14 Nm
SB140 | OWNER'S MANUAL
09
Apply grease to main pivot cavities of Rear
Triangle. Slide Rear Triangle Assembly onto
main pivot and secure with Main Pivot Collet
Axle (3.1) and Routing Collet Nut* (3.7), placing
routing feature at the top.
Torque: 25 Nm
Install a plain collet nut (3.2, flat top with no
clamp feature) if kit uses a wireless drivetrain.
QC CHECK
Cycle rear triangle through to make sure motion
is smooth.
Take precaution to make sure link does not
contact seat tube.
10