Frame Assembly - Yeti ARC Owner's Manual

FRAME ASSEMBLY

YETI TIPS
Make sure your tools are in good condition.
A worn allen key can round the hex on a
bolt not allowing for proper torque.
Torque settings are listed throughout the
instructions and on page 7 of this manual.
It is important to prep all bolt threads.
The instructions denote whether to use a
Loctite compound or grease. Reference
Exploded View for assembly part locations
listed in parentheses.
WARNING: Service on Yeti bicycles requires
special knowledge and tools. Yeti Cycles
recommends that all service and repairs be
performed by an authorized Yeti Dealer.
01
Grease 4x H20 Bolts (2.2) and install with
washers (2.1) to frame downtube.
Torque: 4-5 Nm
TOOLS NEEDED
• 2.5mm allen key
• 4mm allen key
• 8mm allen key
• Torque wrench
• Grease
02
Place a Head Tube Cable Port Cover (2.11) into
each recess behind the head tube.
03
Place a Double Port Clamp (2.12) into the
nondrive side cover and a Single Port Clamp
(2.11) into the drive-side cover. Secure with M4
x 25L screws. Tighten until snug. Hardware can
be torqued to 2-3 Nm after housing installation.
ARC | OWNER'S MANUAL
04
Assemble a Lower Port Clamp (2.15) to the
Down Tube Port Cover (2.14) using a Flat Head
M4 x 16L screw. Hardware can be torqued to
2-3 Nm after housing installation.
8