Solid-State Drive (Ssd) - HP ZBook 14u G4 Maintenance And Service Manual

Solid-state drive (SSD)

Description
1 TB, PCIe, Gen3×4, NVMe, MLC
512 GB, PCIe, Gen3×4, SS/DS, Self-encrypting Drive (SED), Opal 2, TLC
512 GB, PCIe, Gen3×4, SS, NVMe, MLC
512 GB, SATA-3, FIPS-140-2, TLC
256 GB, PCIe, Gen3x4, NVMe, TLC
256 GB, PCIe, Gen3x4, NVMe, MLC
256 GB, SATA-3, Self-encrypting Drive (SED), Opal 2, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5.
Disconnect the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid–state drive.
Bottom cover on page
Battery on page
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
29).
34).
Component replacement procedures
Spare part number
937005-001
937011-001
937010-001
937009-001
937008-001
937007-001
937006-001
37