Table of Contents
Advertisement
NOTE:
There are five different sizes of rubber screw covers. Be sure that you reinstall them over the correct
screws, as shown in the following images.
The rubber-screw cover sizes are shown in the following image.
The rubber-screw cover locations are shown in the following image.
NOTE:
If installing new rubber screw covers, carefully inspect for adhesive tape liner inside the cap and
remove if present.
To properly insert the rubber covers, be sure to orient the covers in the correct direction:
1.
Place the lower edge into the recess (1), followed by the higher edge (2).
32
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Advertisement
Table of Contents
Troubleshooting
