Configuration - Omega DTG-RTD100 Series User Manual

3.4 Configuration

Lid/Cover Removal
To access the USB programming connector on your meter, the enclosure lid/
cover must be removed. Four screws must be removed. Be careful to not lose or
discard these screws. These screws play a vital part in providing the water tight
seal on your unit.
The same four screws removed in this procedure must be
re-installed into your meter housing or you will not have the
proper water tight seal. Failure to install these screws correctly
may result in damage to your unit when the meter is exposed
to wet conditions.
When reinstalling enclosure screws they must be tightened to
9 in-lb ±10%.
REMOVE THESE FOUR SCREWS
THE METER FRONT COVER
Connecting your meter to your computer
A USB Programming cable was included with your unit. This cable is only used
during the setup and configuration of your meter. Note, this cable does not
remain connected during normal use.
IN ORDER TO REMOVE
Figure 3-6. Lid/Cover Removal
Setup & Configuration
CAUTION:
NOTE:
3
3-4