Table of Contents
Advertisement
coffee in the grinder. The machine is, however, guaranteed
to be new.
•
You should customise water hardness as soon as possible
following the instructions in the section "Setting water
hardness" (page 15).
1. insert the power cable connector in socket at the back
of the appliance and connect the appliance to the mains
electricity supply (fig. 1). make sure the main switch at the
back of the appliance is pressed down (fig. 2).
you must choose the language (the languages scroll through at
intervals of about 3 seconds):
2. when english appears press the
seconds (fig. 3) until the display shows "eNgliSh set".
Then follow the instructions indicated on the display:
3. "FILL TANK" : remove the water tank, fill to the MAX
line with fresh water (fig. 4a) then insert back into the
appliance (fig. 4B).
4. place a container with a minimum capacity of 100 ml under
the cappuccino maker (fig. 5).
5. "TURN STEAM KNOB": turn the steam knob to the I position
(fig. 5). "hoT WaTer Confirm?" appears on the display;
6. To confirm press
water from the cappuccino maker and then turns off
automatically.
7. Turn the steam knob to the "o" position.
The coffee machine is now ready for normal use.
Please note :
•
When setting up the appliance, you need to make 4-5
cups of coffee or 4-5 cappuccinos before the appliance
starts to give satisfactory results.
TURNING THE APPlIANCE ON
Please note :
Before turning the appliance on, make sure the main switch at
the back of the appliance is pressed down (fig. 2).
each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only once this cycle is complete.
Danger of scalding!
during rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath. avoid contact with
splashes of water.
•
Press the
button to turn on the appliance (fig. 6).
The message "heating up please wait" is displayed.
When the heating up is complete, the message changes to
"rinsing". By circulating hot water, the appliance heats both
the boiler and the internal circuits.
button for a few
: the appliance delivers hot
The appliance is at temperature when the message indicating
the taste and quantity of coffee is displayed.
TURNING THE APPlIANCE OFF
each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of scalding!
during rinsing, a little hot water comes out of the coffee spouts.
avoid contact with splashes of water.
To turn the appliance off, press the
appliance performs a rinse cycle then turns off (stand-by).
Please note:
if you will not be using the appliance for some time, unplug it
from the mains socket:
•
first turn the appliance off by pressing the
(fig. 6);
•
press the main switch (fig. 2).
Important!
Never press the main switch while the appliance is switched
on.
MENU SETTINGS
When you access the settings menu by pressing the meNu button, the
following menu items can be selected: descale, adjust time, auto-
off, auto-start, Set temperature, energy saving, Water hardness, Set
language, install filter, replace filter, default values, Statistics.
Descale
For instructions on descaling, see page 14.
Adjust time
To adjust the time on the display, proceed as follows:
1. press the MENU button to access the menu;
2. press the
or
displayed;
3. press the button
4. press the
or
5. press the
button to confirm;
6. press the
or
7. press the
button to confirm.
The time is set: press MENU to exit menu.
Auto-off
auto-off can be set so that the appliance turns off after 15 or 30
minutes, or after 1, 2 or 3 hours.
1. press the MENU button to access the menu;
2. press the
or
3. press the button
4. press the
or
9
button (fig. 6). The
button until "adjust time" is
;
button to change the hour;
button to change the minutes;
button until "auto-off" is displayed;
;
until the number of minutes/hours
button
Advertisement
Table of Contents
Troubleshooting
