Connecting To The Mains Supply; Putting Battery In The Remote Control - Grundig Ovation 3 Instruction Manual

CONNECTION AND PREPARATION

Connecting to the mains supply

Notes:
Check that the mains voltage on the type
7
plate (on the bottom of the hi-fi system)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
Before connecting the AC power cord
7
to the wall socket, ensure that all other
connections have been made.
1
Insert the supplied mains cable into the
»AC ~ « socket on the hi-fi system.
2 Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains
7
with the power cord. Pull out the power
plug if you want to completely disconnect
the hi-fi system from the mains.
Make sure the power plug is easily
7
accessible during operation and not
hindered by other objects.
12
ENGLISH
Putting battery in the remote
control
1
Remove the cover of the remote control by
sliding it backwards and pulling out.
2 Open the battery compartment by pushing
the tab and sliding the battery tray out.
3
Insert one CR2025 battery with the correct
polarity as shown on the battery tray.
4
Slide the battery tray into the battery
compartment.
5 Install the cover of the remote control by
sliding it forwards and pushing until it clicks
into its place.
Notes:
Do not expose the battery to extreme heat,
7
caused for example by direct sunlight,
heaters or fire.
Remove the battery when it is flat or when
7
you know that the hi-fi system will not be
used for a long period of time.
Environmental note:
Batteries, including those which do not
7
contain heavy metal, should not be
disposed of with household waste. Always
dispose of used batteries in accordance
with local environmental regulations.
---------------------------------------