Empire Comfort Systems DVP42DP31-2 Installation Instructions And Owner's Manual page 13

Flush Wall Installation
Combustible Surround Installation
26928-0-0110
Figure 12
Figure 13
Attention: Cold climate installation recommendation:
When installing this unit against a non-insulated exterior
wall, it is recommended that the outer walls be insulated to
conform to applicable insulation codes.
Vent Runs (Figures 14 through 18)
In planning the installation for the fireplace, it is necessary to install
certain components before the appliance is completely positioned
and installed. These include the direct vent system, gas piping for the
appliance and the electrical wiring. (If the fan option is used.)
The appliance can be mounted on any of the following surfaces:
1. A flat, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four (4) corner supports. (Example: Four (4) concrete
masonry blocks.) These supports must be positioned so they
contact all four (4) perimeter edges on the bottom of the unit.
Note: Fireplace must be mounted above floor surfaces. Doors will
not operate properly if fireplace rests below room flooring.
VERTICAL, 90° ELBOW WITH HORIZONTAL
TERMINATION
50 1/2" (1283mm)
TO BOTTOM
OF UNIT
3" (76mm)
MINIMUM CLEARANCE
TO COMBUSTIBLES
VENT CAP/
THIMBLE
WALL FIRESTOP
Figure 14
Page 13