Trip Matrix Logic Tmagapc; Identification; Application; Setting Guidelines - ABB RELION 670 Series Applications Manual

1MRK 505 343-UEN B
tWaitForPHS : Sets a duration after any of the inputs 1PTRZ or 1PTREF has been activated
during which a phase selection must occur to get a single phase trip. If no phase selection has
been achieved a three-phase trip will be issued after the time has elapsed.
16.2

Trip matrix logic TMAGAPC

16.2.1

Identification

Function description
Trip matrix logic
16.2.2

Application

The trip matrix logic TMAGAPC function is used to route trip signals and other logical output
signals to different output contacts on the IED.
The trip matrix logic function has 3 output signals and these outputs can be connected to
physical tripping outputs according to the specific application needs for settable pulse or
steady output.
16.2.3

Setting guidelines

Operation : Operation of function On / Off .
PulseTime : Defines the pulse time when in Pulsed mode. When used for direct tripping of
circuit breaker(s) the pulse time delay shall be set to approximately 0.150 seconds in order to
obtain satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
OnDelay : Used to prevent output signals to be given for spurious inputs. Normally set to 0 or a
low value.
OffDelay : Defines a delay of the reset of the outputs after the activation conditions no longer
are fulfilled. It is only used in
the off delay time shall be set to at least 0.150 seconds in order to obtain a satisfactory
minimum duration of the trip pulse to the circuit breaker trip coils.
ModeOutputx : Defines if output signal OUTPUTx (where x=1-3) is Steady or Pulsed .
16.3

Logic for group alarm ALMCALH

16.3.1 Identification
Function description
Logic for group alarm
Application manual
IEC 61850 IEC 60617
identification identification
TMAGAPC -
Steady mode. When used for direct tripping of circuit breaker(s)
IEC 61850 IEC 60617
identification identification
ALMCALH -
Section 16
SEMOD167882-2 v3
ANSI/IEEE C37.2
device number
-
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
ANSI/IEEE C37.2
device number
-
Logic
IP15121-1 v4
M15321-3 v11
M15291-3 v5
637