Led Error Messages; Image Problems - Vivitek HK2288 User Manual

LED Error Messages

E C
RROR ODE
Standby
Start warm up
Lamp Ready
Cooling
1W MCU detects scaler stops working
(initial fail)
Over Temperature
Thermal Break Sensor error
Lamp strike fail / ballast connector open
Lamp voltage too low
Ballast fail
Ballast communication fail
Ballast over temp
Lamp fail
Fan 1 error
Fan 2 error
Fan 3 error
Fan 4 error
Fan 5 error
Case Open
DMD error
T1 error
Color wheel error
ASIC not ready
Lamp Blower stops(Not running.)
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above , please contact your service center.

Image Problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the specified range.
4. Check that the projector lens is clean.
Problem: The image is reversed
Check the Orientation setting on the Setup menu of the OSD.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.
M
ESSAGES
P L
OWER ED
G
REEN
ON
Flashing(Green)
Green
Flashing(Green)
2 blinks
OFF
4 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
6 blinks
6 blinks
6 blinks
6 blinks
6 blinks
7 blinks
8 blinks
OFF
9 blinks
8 blinks
5 blinks
– 35 –
DLP Projector—User's Manual
T L
EMP ED
R
ED
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
L L
AMP ED
R
ED
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
7 blinks
8 blinks
10 blinks
1 blinks
5 blinks
1 blinks
2 blinks
3 blinks
4 blinks
5 blinks
OFF
OFF
1 blinks
OFF
1 blinks
6 blinks