Sharp AR-C360P Software Installation Manual page 26

8. Pull the finisher platform about half way out,
then loosen the screw on the locking piece (
viewed from the opposite direction) so that it
drops through the slot below it. This keeps the
platform from moving while you attach the
finisher to it.
9. Position the finisher on the stand and attach
it with two screws from the back.
! :
10. Lift the locking piece back up and tighten the
screw firmly. Be sure it's out of the way and
the screw is tight—otherwise the platform
will not move freely.
11. Install the stacker, making sure the hooks
are firmly engaged and that the lever on the
finisher is positioned above the stacker (
7
!
).