Parallel Connection - Sharp AR-C360P Software Installation Manual

®
Windows

Parallel Connection

1 Connect the parallel Interface
For direct connection to a PC
This port requires a bi-directional (IEEE 1284
compliant) parallel cable. Cable must be shielded
and UL and CSA approved.
1. Make sure the printer is powered off.
2. Connect a parallel cable between the printer
and computer.
Installation
2 Install the Fiery PostScript Printer Driver
The installation procedure may vary slightly
depending on the operating system you are using.
Drivers are provided for Windows
and NT 4.0.
1. Make sure the cable is connected to your printer
and PC and your printer is turned OFF.
2. Insert the driver CD (CD1) supplied with your
printer into your CD-ROM drive. The CD will
autorun.
If it doesn't autorun, click
→
Start Run
CD-ROM drive. Double-click Install.exe. Click
OK.
3. Select your language.
4. The License Agreement appears. Click Next to
accept.
5. Select Custom Install to select software tools to
be installed with the printer driver. To install
only the printer driver, select Minimal Install
and skip the next step.
6. The Software Installation screen appears. Click
the Printer Driver Installer button.
7. Click Local printer. Click Next.
8. Select the LPT1 port. Click Next.
9. Select your printer model.
10.Select the PS (PostScript) printer emulation.
Click Next.
11.If prompted, type a printer name for your
printer. Click Next.
12.If prompted, select "do not share this printer."
Click Next.
13.Follow the on-screen instructions to compete
the installation. Click Finish.
14.Switch the printer ON.
To print a test page:
15.Click Start → Settings → Printers.
16.Right-click the printer icon.
11
NOTE
®
XP, 2000, Me,
→
Browse. Browse to your