Sharp AR-C360P Software Installation Manual page 25

3. Place the finisher cover near the back of the
finisher. Locate the tab (
the cover.
4. Hold the clear band perpendicular to the cover
and slip one end over the tab (
the band 90 degrees (
toward the finisher:
5. Slip the other end of the band (
the retainer on the finisher and secure it
with the small stopper (
! ) on the right side of
!
), then pivot
"
) so that it is aimed
!
) through
"
).
6. Place the large stopper over the tab on the
cover and turn it to lock it in position.
7. Attach the cover to the finisher and close it.
6