How To Call; Service Inspection List - Mitsubishi Electric JT-SB116JH-G-NA Handbook

Hide thumbs Also See for JT-SB116JH-G-NA:
Table of Contents

Advertisement

11. How to call

Symptom
Air blow is too weak to dry hands
quickly.
Water leaks from the product.
Air does not blow immediately after
turning on the circuit breaker and
inserting hands.
Warm air does not blow.
The product has an abnormal odor.

12. Service inspection list

Location
Electric wiring
Operation
Heater
Lamps
Wall installation
1 Check if the filter is clogged.
2 Isn't the air speed switch set at the STANDARD position?
1 Check if the drain tank is filled up. (Empty the drain tank.)
*Note: Drain water will overflow onto the floor when the drain tank is
filled up beyond its capacity.
2 Is the drain tank installed properly?
Initial setting takes 1.5 seconds after turning on the circuit breaker.
Operation is disabled in the meantime.
Is the heater switch turned ON?
1 Check if the drain tank is filled up. (Empty the drain tank.)
2 Check the inside of the drain tank for any foreign matter. (Remove it.)
3 Is the inside of the side cover cleaned up?
Are lead wire connectors connected securely?
Is the wiring correct?
Does it operate properly?
Isn't there any abnormal noise, vibration, etc?
Is warm air blown?
Do the power lamp (LED1), the heater lamp (LED2) (with the
heater switch ON), and blue illumination lamps (LED10, 11)
come on?
Isn't there clearance between the product and the back wall?
─ 16 ─
Remedy
Inspection Item
Check Result

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jt-sb116jh-w-na

Table of Contents