Mitsubishi Electric JT-SB116JH-G-NA Handbook page 20

4 Unscrew the clamping screw, and remove the PCB cover for the filter
circuit board (JT-34F).
(One PTT screw 4×6, indicated by )
5 Disconnect the lead wires from the filter circuit board (JT-34F).
6 Remove the spacers (four locations, indicated by
move the filter circuit board (JT-34F).
(Pinch the spacers from the back for easier removal.)
(8) Terminal block
1 Remove the TB cover. → See (7) 1 to 2.
2 Unscrew the clamping screws, and remove the terminal block.
(Two PPT screws 4×20, indicated by )
Assembly precaution
Take care not to pinch the lead wires.
Assembly precaution
Set the marking of the thermal fuse lead wire directly underneath the
terminal block. (Indicated by )
), and then re-

─ 20 ─
PCB cover
Filter circuit board (JT-34F)
Terminal block
Thermal fuse lead wire