Table of Contents
Advertisement
Initial Status Setting
The copier will assume the initial settings when it is turned on, when the
CLEAR ALL key is pressed, or when the auto clear interval has
elapsed after a copy run. Use this program to establish the initial
settings.
When the "INITIAL STATUS SETTING" key is pressed, the following
display will appear.
Transfer Belt Position
This program is used to select the home position of the transfer belt
either to the B/W side or the COLOR side. The default setting is the
COLOR side.
KEY OPERATOR PROGRAMS
KEY OPERATOR PROGRAMS
INITIAL STATUS SETTING
SET THE INITIAL STATUS.
ESTABLISH NEW INITIAL
SETTINGS.
1/4
RETURN TO THE FACTORY DEFAULT
SETTINGS.
To establish new initial settings
1.
Press the "ESTABLISH NEW INITIAL SETTINGS." key.
2.
Select all initial settings on the operation panel.
The following functions cannot be set:
Number of copies, XY zoom, automatic copy ratio selection,
interrupt, special functions, information, and LCD contrast.
3.
Press the "OK" key.
To return to the factory default settings
Press the "RETURN TO THE FACTORY DEFAULT SETTINGS."
key.
KEY OPERATOR PROGRAMS
TRANSFER BELT POSITION
1/4
1.
Press the key of the desired home position, "COLOR" or
"B/W".
2.
Press the "OK" key.
OK
1/4
OK
COLOR
B/W
1/4
21
Advertisement
Table of Contents
