Scroll compressors, DSF090 to DSF530 | Mechanical connections
Table 15: Additionnal rigid spacer
Additionnal rigid spacer
DSF215U-230U-255U-275U-315U-331U-355U-375U
DSF300U
Tandem requirements DSF465T-525T-600T mounting
The compressors must be mounted with rigid mounting spacers on rails. Rubber grommets and spacers must be
installed below the rails.
The rigid mounting spacers and rubber grommets are included in tandem accessory kits.
1
2
3
4
Tandem requirements DSF400X-470X-500X-525X mounting
The large compressor, DSF270,325, is mounted with rigid spacers on the rails.
The DSF130, 175,200 compressor is fixed on beams by rigid spacer, and the beams are mounted with rigid spacers
on the rails. Rubber grommets and spacers must be installed below the rails.
Figure 28: DSF270-325
1
2
3
4
5
© Danfoss | Climate Solutions | 2023.06
Additional right spacer(to be added on the smallest compressor of the tan‐
dem)
7mm
14mm
1
Tightening torque 15Nm
2
Not supplied HM8mm 0.31 inch
3
Tightening torque 15 Nm
4
3mm (0.12inch) Thickness
Supplied with the compressor
Included in manifolding kit
Not supplied
Figure 29: DSF130-175-200
AB309735209512en-000603 | 25
6
7
5