Electrolux TE1120 User Manual page 20

20 www.electrolux.com
Problem
Unsatisfactory
drying result.
The loading
door does not
closed
Err (Error) on
the display.
No drum light
Abnormally
elapsing time
on the display.
Programme in-
active.
Drying cycle too
short.
Possible cause
1)
Incorrect programme selection.
The filter is clogged.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the humidity sensor in the
drum.
Incorrect remaining laundry mois-
ture degree.
The condenser is clogged.
The filter not locked in the posi-
tion.
The laundry is locked between
the door and the seal.
You try to change the programme
or the option after the start of the
cycle.
The option you try to activate is
not applicable with the selected
programme.
Defective drum lamp.
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The water container is full.
Too small laundry volume.
The laundry is too dry.
Remedy
Do the selection of the applicable
2)
programme.
3)
Clean the filter.
Obey the maximum load volume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust remaining laundry moisture
4)
degree.
Clean the condenser.
Put the filter in the correct posi-
tion.
Put the load correctly in the drum.
Turn the tumble dryer off and on.
Make the new selection.
Turn the tumble dryer off and on.
Make the new selection.
Contact the service centre to re-
place the drum lamp.
The automatic procedure — this
is not the appliance malfunction.
Drain the water container, push
the Start/Pause button.
Do the selection of time pro-
gramme. The time value must be
related to the load. To dry 1 item
or small quantities of the laundry
we recommend to use short
times.
Do the selection of the time pro-
gramme with longer time.
3)
3)