Makita DJR186 Technical Information page 21

7 Wiring diagram
Wiring to Motor housing
Put Brush holder's Lead wire
(black) into this lead wire holder.
Brush holder
Pass Lead wire through Line filter, and wind it around
Line filter one time as shown in the figure on the
right.
Wiring to Terminal
Connect Flag receptacle as shown below.
Brush holder
Flag receptacle
Fig. 7-1
Put Brush holder's Lead wire
(red) into this lead wire holder.
Lead wire
21 / 22
Brush holder
Put Brush holder's Lead wire
(red) into this lead wire holder.
Brush holder
Line filter (if used)