Table of Contents
Advertisement
Entering and Exiting Setup Utility
1.
Turn on the computer.
2.
When <F2> to enter System Configuration Utility appears, press F2.
3.
Change to the desired settings. Refer to the next section.
4.
Select Exit menu; then, press Enter.
5.
Select one of the exit methods, and press Enter.
6.
Confirm the message and press Enter again. The system restarts.
When the Setup Utility is opened, power management does not work. Do
not close the display cover.
Changing Setting of Setup Utility
To change the settings:
1.
Use → or ← key to select the menu.
2.
Use ↑ or ↓ key to select the item.
5
If the item has
Press Enter to enable or disable the item.
enabled. _ mark means disabled.
If the item has no mark (except Date and Time of Main menu and Set Password
of Security menu):
1. Press Enter to open the sub menu.
2. Use Tab key to highlight the value; then use ↑ or ↓ key to select the value.
The value with • is being selected.
3. Use Tab key to highlight OK; then press Enter.
To set Date and Time:
1. Press Enter.
2. Use arrow keys to highlight the value; then use minus key or space bar to
change the value.
3. Use arrow keys to highlight OK; then press Enter.
Minus or Space key : Changes the value.
3.
Close the Setup Utility according to the steps above.
5-2
or _:
mark means the item is
Advertisement
Table of Contents
