Table of Contents
Advertisement
5.
In the Register an icon and network name dialog box, select the SHARP icon or
Windows icon, then, click the Select icon button.
6.
Select an icon and click OK.
7.
Type a network name, then, click OK. The selected icon appears on the main
screen of the Network Setup Utility window.
It takes a moment to load and register the network settings.
Using or Switching to Network
Using or Switching to Loaded Network
To use or switch the loaded network, confirm the computer is ready to connect into
the network and follow these steps.
1.
Run the Network Setup Utility to display the Network Setup Utility window.
2.
Select the appropriate network icon in the Network Setup Utility window.
3.
Click OK.
• Make sure the computer is connected to the proper environment.
• If your hardware or software configuration has been changed, you may
not be able to switch to the network properly. In this case, you may
need to reconfigure the network settings.
Automatically Switching to Available Network
The computer supports the auto-switching function, "Auto Pilot," automatically to
detect one of the available networks registered and switch to it.
1.
Run the Network Setup Utility to display the Network Setup Utility window.
2.
Click the Auto Pilot icon ( ).
3.
Read the message in the confirmation window and click OK.
• It will take a moment to switch to the auto pilot mode.
• To exit from the auto pilot mode, click the icon (
) again.
4-21
4
Advertisement
Table of Contents
