Instructions For Attaching A Vesa-Compliant Mount - Sharp IT-23M1U Operation Manual

Instructions for attaching a VESA-compliant mount

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the
customer's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard.
- The six screw holes on the section to be
attached have a gap of 100 mm between them.
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
- Be careful not to over bend the cable or add
extension cords as this could lead to
malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or
stand.
CAUTION!
- Be careful not to get your fingers pinched
between the display and stand nor to let the
stand drop. These could lead to injury.
1. Remove the cables.
2. Spread out a soft cloth on a suitable horizontal
surface. Being careful not to damage the
monitor, gently lay the monitor on it display-side
down.
3. Remove the two screws and then remove the
rear cover of the stand.
IT-23M1U_gb_02.P65 55
4. Remove the six screws and then remove the
stand from the monitor.
Notes:
- The stand is specially made for use with this
monitor. Once having removed the stand,
never attempt to attach it to another
equipment.
- Once having removed the screws, store them
together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to a
malfunction.
5. Attach the arm to the monitor with the six screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 6 mm - 8 mm (0.24" -
0.31") protruding from the surface to be attached.
Using different screws could cause the monitor to
fall off or to be internally damaged.
6 mm - 8 mm (0.24" - 0.31")
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
E55
2004/08/20, 10:44