Setting Up Your Camera; Pre-Installation Checklist; Setting Up Your Housing; Opening The Housing - Ikelite DMC-ZS100 Quick Start Manual

Setting Up Your Camera

Pre-Installation Checklist

1. Insert a fully charged camera battery.
2. Insert a properly formatted memory card.
3. Set AF Assist Lamp and Red-Eye Removal to "OFF."
4. Set Eye Sensor LVF/Monitor Switch to "MON."
5. Set Touch Settings - Touch Screen to "OFF."
6. Set Step Zoom function in the Custom menu > zoom lever >
CAUTION: Zoom the camera in small steps. If zoomed past
the 200mm setting, the camera lens may contact the ports lens and
"lock-up" the camera functions. If this occurs, turn the camera off
and then on again to reset.
7. Check the Picture Size and Quality.
NOTE: When using "M" manual mode, use the UP arrow button
on the menu pad to toggle between aperture and shutter speed
function, and use the rear dial to change settings.

Setting Up Your Housing

Opening the Housing

1. Push the lid snap lock forward and start to lift the curved end away
from the housing.
Q
7