Table of Contents
Advertisement
8. Like regulators and other pressure-sensitive equipment,
we recommend careful care and cleaning along with annual
replacement of the factory seals.
Troubleshooting
Water enters the housing
•
Re-clean and re-install the main o-ring.
•
Take the housing underwater without a camera installed to ensure
that the leaking has been corrected.
Photos are over-exposed (too light)
•
Adjust aperture (smaller), shutter speed (faster), or ISO (lower)
setting.
•
Move lights(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Photos are under-exposed (too dark)
•
Adjust aperture (larger), shutter speed (slower), or ISO (higher)
setting.
•
Move light(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Strobe will not fire
•
Turn on strobe.
•
Make sure that the camera's flash is set to fire on every photo.
•
Check that the fiber optic cord is attached.
13
Advertisement
Table of Contents
