Status Indicators - Sharp AL-1220 Operation Manual

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring to both the
table below and the relevant page.
Drum replacement
required indicator
TD cartridge
replacement
required indicator
6
Misfeed indicator
SPF misfeed
indicator
The paper tray indicator is
blinking.
"CH" is blinking in the display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.
40
Be sure to use only genuine SHARP parts and supplies.
Indication
Steadily
lit
Blinking
Steadily
lit
Blinking
Blinking
Blinking
Cause and remedy
Replacement of drum cartridge will be needed
soon. Prepare a new cartridge.
Drum cartridge must be replaced. Replace it
with a new one.
Replacement of TD cartridge will be needed
soon. Prepare a new cartridge.
TD cartridge must be replaced. Replace it with
a new one.
A misfeed has occurred. Remove the misfed
paper referring to the description of "Misfeed
removal."
In the AL-1250/AL-1521, the lower side cover
may be open. If so, close it.
An original misfeed has occurred in the SPF.
Remove the misfed originals referring to the
description of "Misfeed in the SPF".
The paper tray is not installed properly.
Push the tray into the copier securely.
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover
securely by pressing the round projections
near the side cover open button.
Paper tray or bypass tray is empty. Load copy
paper.
A misfeed has occurred in the paper tray or
bypass tray. Remove the misfed paper.
Paper tray is not securely installed. Push the
tray in securely.
The copier will not function. Turn the power
switch off, remove the power cord from the
outlet, and contact our Technical Assistance
Department at 1-(630)378-3590.
See
page:
44
29
44
28
34
–
38
–
28
–
13
34
–
–