Table of Contents
Advertisement
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following alphanumeric
codes appear in the display, solve the problem immediately referring to both the table below and
the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication
Drum replacement
required indicator
Toner required
indicator
Misfeed indicator
Maintenance
indicator
"CH" is blinking in the display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
Press the clear (
1
Press and hold down the clear (
2
of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
Cause and remedy
Drum cartridge must be replaced. Service by
Steadily
lit
an authorised SHARP service technician is
required.
Toner will be needed soon.
Steadily
lit
Toner is required.
Blinking
A misfeed has occurred. Remove the misfed
Blinking
paper referring to the description of "Misfeed
removal."
Steadily
Service by an authorised SHARP service
lit
technician is required.
The TD cartridge is not installed. Check if the
cartridge is installed.
Side cover is open. Close the side cover
securely by pressing the round projections
near the side cover open button.
Paper tray is empty. Load copy paper.
A misfeed has occurred in the paper tray.
Remove the misfed paper.
Paper tray is not securely installed. Push the
tray in securely.
The copier will not function. Turn the power
switch off, remove the power cord from the
outlet, and contact your SHARP dealer.
) key to reset the display to zero.
) key for approximately 5 seconds. The total number
See
page:
_
20
20
26
27
6
20
_
10
24
_
_
29
Advertisement
Table of Contents
