Status Indicators - Sharp AR-122E Operation Manual

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication
Developer
replacement
required indicator
Toner cartridge
replacement
required indicator
Misfeed indicator
Maintenance
indicator
Power save indicator is
steadily lit.
The paper tray indicator is
blinking.
"CH" is blinking in the
display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.
A letter and a number appear
alternately.
A letter and a number appear
alternately.
Steadily Developer is required. contact your authorised
lit service representative.
Steadily Replacement of Toner cartridge will be needed
lit soon. Prepare a new cartridge. (AR-152T)
Toner cartridge must be replaced. Replace it
Blinking
with a new one. (AR-152T)
A misfeed has occurred. Remove the misfed
Blinking paper referring to the description of "MISFEED
REMOVAL".
Steadily Service by an authorised SHARP service
lit technician is required.
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
The unit is in the auto power shut-off mode.
Press the start (
shut-off mode.
The paper tray is not installed properly. Push the
tray into the unit securely.
The toner cartridge is not installed. Check if the
cartridge is installed. If "CH" is blinking even if a
cartridge is installed properly, contact your
SHARP service centre immediately.
Side cover is open. Close the side cover
securely by pressing the round projections near
the side cover open button.
The paper tray is empty.
Load paper.
A misfeed has occurred in the paper tray, single
bypass. Remove the misfed paper.
Paper tray is not securely installed. Push the tray
in securely.
The scan head locking switch is locked. Unlock
the scan head locking switch and turn the power
switch off/on.
The unit will not function. Turn the power switch
off and then switch it on, and if there is again an
error, remove the power cord from the outlet, and
contact your authorized service representative.
You will not be able to use the toner cartridge
anymore (Toner Cartridge End of life). Contact
your authorised service representative.
Cause and remedy
) key to cancel the auto power
Page
31
21
21
28
31
18
18
–
6
21
–
8
28
–
–
–
–
27