Copier Trouble; Misfeed Removal - Sharp AL-1220 Operation Manual

6
This chapter describes misfeed removal and troubleshooting.

MISFEED REMOVAL

When the misfeed (
of a misfeed.
If a misfeed occurs when using the SPF, a number may appear in the display after a minus
sign. This indicates the number of the originals that must be returned to the document feeder
tray after a misfeed. Return the required number of originals. Then this number will disappear
when copying is resumed or the clear (
When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator
will blink, while the misfeed (
see "E Misfeed in the SPF" on page 38.
Ensure that the bypass tray is open and then open the side cover while pressing the
1
6
side cover open button.
Check the misfeed location. Remove the misfed paper following the instructions for
2
each location in the illustration below.
If
If the misfed paper is seen from
this side, proceed to "C Misfeed
in the transport area". (p. 36)
34

COPIER TROUBLE?

) indicator blinks or
) indicator will remain off. For a misfeed of originals in the SPF,
If the AL-1250 and AL-1521 are turned on with the lower side cover open, the
misfeed ( ) indicator will blink. In this case, close the lower side cover. The
misfeed ( ) indicator will go out.
blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 35)
blinks in the display, the copier will stop because
) key is pressed.
If paper is misfed here, proceed to "B
Misfeed in the fusing area". (p. 35)
If paper is misfed here, proceed to "A
Misfeed in the paper feed area". (p. 35)
If paper is misfed here, proceed to "D Misfeed in the
lower paper feed area". (p. 37) (AL-1250/AL-1521 only)