Programming; Remote Control; Wireless Keyless Entry; To Erase The Memory - Chamberlain C2405 User Manual

Programming

Remote Control

Below are the steps to program a new or existing remote control. Test
remote control before reprogramming.
1. Press and release the LEARN Button on the
garage door opener.
2. Press and hold the button on the remote
control that you wish to use. Release the
button when the garage door opener lights
blink or two clicks are heard.
Note: Remote may vary.
OR
For Multi-Function Control Panel
1. Press the LEARN button on the
door control to enter
Programming Mode.
2. Press the LEARN button again, the
LED will flash once.
3. Press the button on the remote
control that you wish to operate
your garage door.
For Push Button Door Control
1. Press and hold the Light button
and the Push button until the
Push button LED begins to blink.
2. Press the button on the remote
control that you wish to operate
your garage door.
If your vehicle is equipped with a
Homelink , you may require an external adapter depending on the
®
make, model, and year of your vehicle.
Visit www.homelink.com for additional information.
LEARN Button
OR
Push Button
Light/Learn
Button

Wireless Keyless Entry

Refer to the instructions provided with your keyless entry OR go to
Chamberlain.com to download instructions.

To Erase the Memory

Erase ALL Remote Controls and
Keyless Entries
Press and hold the LEARN button until
the LED goes out (approximately 6
seconds).
All remote controls and keyless entries are now erased.
Erase ALL Devices (Including myQ® enabled accessories)
1. Press and hold the LEARN button until the LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button until the LED goes
out. All codes are now erased.
Erase the Wi-Fi Network from the
Garage Door Opener
Press and hold the adjustment button
until 3 beeps are heard
(approximately 6 seconds).
Programming
Buttons
LEARN
Button
Adjustment
Button
7