Connecting The Refrigerator - Dometic RM8506 Instruction Manual

Connecting the refrigerator

5.7 Securing the refrigerator
!
CAUTION!
Only drill through the receptacles provided, otherwise foamed compo-
nents, including cables, can be damaged.
I
NOTE
Attach the side walls or the attached strips so that the screws are tight,
even when under increased loads (while driving).
Proceed as follows (fig. m, page 7):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws (1) through the four plastic washers in the sides of the
refrigerator, and further into the wall.
➤ Put the caps (2) onto the screw heads.
6 Connecting the refrigerator
6.1 Connecting to the gas supply
A
NOTICE!
•
This refrigerator may only be connected to the gas supply by a spe-
cialist in accordance with the applicable guidelines and standards.
•
Only use cylinders of propane or butane gas (not natural gas or city
gas) with an approved pressure reduction valve and suitable head.
Compare the pressure information on the type plate with the pres-
sure information on the pressure regulator on the propane or butane
gas cylinder.
•
Only operate the refrigerator at the pressure shown on the type
plate.
•
Please note the pressures which are permitted in your country. Use a
DIN-DVGW-approved pressure regulator with a fixed setting:
– The following applies for Germany: DIN EN 12864
– The following applies for Europe: EN 732 and EN 1949
I
NOTE
The refrigerator is equipped for a connection pressure of 30 mbar. Use
a 50/30 mbar pressure regulator when connected to a 50 mbar system.
22
RM(x)8xx6
EN