Monterey 208 LS Cuddy Owner's Manual page 9

●
If canvas gets wet during use, remove side curtains and open windshield
so seams can dry out. The air circulation will allow all canvas to dry and
prevent the growth of mildew. Never store damp canvas.
●
Occasionally set up all canvas and curtains and hose down with fresh
water to remove accumulated soot and dirt. Sweep or brush the
underside of the canvas to prevent the accumulation of dirt and mildew.
●
The outer canvas surfaces can be cleaned with a soft scrub brush and
either automotive convertible top cleaners or household cleaners suitable
for use on vinyl surfaces. The underside of the canvas may be
periodically sprayed with a spray disinfectant to prevent the growth of
mildew.
●
Do not store or dock your boat under trees. Tree sap is very corrosive to
canvas and can also be harmful to gelcoat and vinyl interiors.
●
Adjust top bows to eliminate pockets in which rain water can accumulate.
Never trailer your boat with the convertible/bimini canvas
(including side curtains, aft curtain, windshield connector, bow
cover and cockpit cover) up. Boat canvas is not designed to
withstand the high wind loads of trailering. Severe wind damage
can occur such as torn material, fastener pull-out and frame
distortion. Damage caused by trailering is not covered under
warranty.
The weight of this accumulated water can collapse the top or bag the
canvas.
●
Zippers and snaps should never be forced.
●
When trailering, dismantle, roll and securely stow all canvas to prevent
damage. Monterey recommends purchasing a transportation cover to keep
your boat clean on the road. Your Monterey Dealer will assist you in finding
a suitable cover (not available from Monterey Boats).
●
Roll curtains, do not fold, and store in a clean, dry place.
●
Do not allow petroleum products or bug sprays to come in contact with
canvas.
Your Monterey boat is basically an open vehicle. Therefore, in
spite of well-designed and well-fitting canvas enclosures, your
boat is not waterproof. We have made every effort to design
these enclosures to conform with the boat, but a certain amount
of leakage may occur, especially at the seam lines. After cleaning
with soap and water, allow seams to thoroughly dry. A vinyl daub
sealant can be applied on the seams to somewhat close the
needle holes according to the manufacturer's instructions.
WARNING
NOTICE
M-3