Step 2: Up And Running - Juniper SRX345 Quick Start Manual

3. Plug the power cord into the SRX345 rear panel.
4. If the AC power source outlet has a power switch, turn it off.
5. Plug the other end of the power cord into the AC power source outlet.
6. If the AC power source outlet has a power switch, turn it on.
7. If you are using a SRX345 Firewall with dual AC power supplies, then repeat Step 3 through Step 5 for the second
power supply.
The SRX345 powers up as soon as you connect it to power. When the PWR and STAT LEDs on the front panel are lit
solid green, the SRX345 is ready to use.

Step 2: Up and Running

IN THIS SECTION
SRX345 Provisioning Options | 6
Initial Configuration Using the CLI | 6
Now that the SRX345 is powered on, let's do some initial configuration to get it up and running on the network.
5