Explanation Of Meter Panel Components - Komatsu AX20 Operation & Maintenance Manual

18.2

EXPLANATION OF METER PANEL COMPONENTS

See the illustration in "METER PANEL COMPONENTS" on page 3-3 for the locations of the following items.
ENGINE WATER TEMPERATURE GAUGE
Engine cooling water temperature gauge indicates the engine
coolant temperature with a needle.
White range: Coolant temperature is normal
Red range: Coolant is overheated
NOTICE
If the indicator enters the red range, stop operations immedi-
ately and park the truck in a safe place. (.) If Then take correc-
tive actions against engine overheating.
See "ACTION WHEN ENGINE HAS OVERHEATED" on page 3-45.
FUEL GAUGE
Fuel gauge displays the level of the remaining fuel with a needle
indicator. Check the remaining fuel level with the engine starting
switch key in the ON position. If the lift truck is on a slope, the
correct fuel level will not be shown, so always check fuel level when
the lift truck is on level ground.
Position A: Fuel level is low
Position B: Fuel tank is full
Do not use up all the fuel: fill the fuel tank before the fuel runs out.
NOTICE
On LPG or Dual-Fuel equipped trucks, the gauge is partially or completely covered by decals referencing
the LPG tank gauge. (See "SAFETY LABELS" on page 2-31.)
BRAKE FLUID LEVEL WARNING LAMP
If this lamp lights up, check the brake fluid level and add fluid.
NOTICE
Always use genuine Komatsu brake fluid.
ENGINE OIL PRESSURE WARNING LAMP
Engine oil pressure warning lamp indicates whether the engine
lubrication oil pressure is normal or not.
When functioning normally, this lamp lights up when the engine
starting switch key is turned to the ON position and goes off after
engine startup. Should the lamp light up during operation, stop
operations immediately and check the engine lubrication system for
any abnormality.
18. EXPLANATION OF COMPONENTS
A
AD803220
B
9JL00065
AD803200
AD803190
3-9