Table of Contents
Advertisement
Connecting the Turbotrimmer :
3
2
Setting the Turbotrimmer
to the working position :
6
9
8
0
A
Starting your Turbotrimmer :
3
C
Trimming along lawn edges
and in awkward places :
6
Filament feed (Tip mechanism
for automatic filament feed) :
1. Push the extension cable
the cable lock
2. Plug the plug
trimmer into the socket
extension cable.
Working position :
Position the additional handle
tilted slightly forward when you hold the Turbotrimmer in the
working position.
1. Unscrew the tightening nut
move the additional handle
to the correct position and tighten
the nut
2. Unscrew the adjusting nut
set the additional handle
B
the correct angle and tighten
the adjusting nut
3. Unscrew the tightening nut
adjust the handle
correct length and tighten the
0
nut
by hand.
4. Press and hold down the adjusting
B
button
to the correct angle, then release the adjusting button
1. Press the start button
The Turbotrimmer starts.
2. Release the start button
The Turbotrimmer switches off.
1. For vertical cutting, loosen the tighten-
ing nut
180 ° and then tighten the nut
by hand.
2. Swivel the plant guard
the park position until it clicks into place.
3
3. Lift the Turbotrimmer by the handle
and additional handle
8
cutting position.
4. When trimming between paving stones,
hold the Turbotrimmer so that the cutting
filament moves slightly above the paved
ground.
The filament is lengthened automatically when the motor is
running using a tip mechanism. A clean cut is only achieved
with the maximum filament length.
1
into
2
on the handle
4
of the Turbo-
5
of the
6
8
,
6
8
by hand.
9
,
6
to
9
by hand.
0
,
A
to the
, set the cutting head
C
on the handle
C
on the handle
8
, turn the additional handle
D
backwards to
6
and turn to the
3
.
4
5
so that the cutting head
7
3
.
3
.
6
8
again
Cutting
D
position
3
Park
position
2
1
7
is
6
7
B
.
D
11
Advertisement
Table of Contents
