Table of Contents
Advertisement
5. Slide the Seat (23) to the front of the Rail (2).
Next, attach a Stop (32) to each side of the Rail
(2) with an M4 x 19mm Screw (69).
Then, attach the Rail Cap (38) to the Rail (2)
with two M4 x 19mm Screws (69).
6. While a second person holds the Console (75)
and the Upright (77) near the Frame (1), connect
the Upright Wire (84) to the Reed Switch Wire
(47). Insert the excess wire into the Frame.
Tip: Avoid pinching the wires. Attach
the Upright (77) to the Frame (1) with four
M8 x 35mm Screws (82); start all the Screws
before fully tightening them.
7. Identify the Right and Left Upright Covers (80,
81), and orient them as shown.
Press the Right and Left Upright Covers (80, 81)
together around the Upright (77) and attach them
to the Upright with two M4 x 19mm Screws (69).
Then, insert the Knob (78) into the Right Upright
Cover (80) and tighten it into the Upright (77).
5
2
69
32
69
69
38
6
75
Avoid pinching
the wires
7
81
69
8
23
32
69
82
84
47
1
77
77
80
78
69
Advertisement
Table of Contents
